| Tue, 27 Nov 2012 13:17:42 +1030 |
Daniel O'Connor |
Updated BMP has a different port name.
|
| Tue, 27 Nov 2012 13:16:47 +1030 |
Daniel O'Connor |
- Add depend target.
|
| Tue, 20 Nov 2012 21:54:06 +1030 |
Daniel O'Connor |
Add flashread/writeblock commands which read/write a block of data to
|
| Sat, 17 Nov 2012 18:03:48 +1030 |
Daniel O'Connor |
Use a 32 bit var to hold address from atoi().
|
| Sat, 17 Nov 2012 12:18:24 +1030 |
Daniel O'Connor |
Add stream read/write commands.
|
| Sat, 17 Nov 2012 12:17:58 +1030 |
Daniel O'Connor |
Reduce prescaler to 2, the flash is capable of 25MHz reads (although
|
| Sat, 17 Nov 2012 12:15:17 +1030 |
Daniel O'Connor |
Use CR/LF to printfs (should probably do the conversion in _write)
|
| Sat, 17 Nov 2012 12:14:38 +1030 |
Daniel O'Connor |
Add test for assert
|
| Thu, 15 Nov 2012 23:40:51 +1030 |
Daniel O'Connor |
- Add flash erase, write & read commands (needs more work).
|
| Wed, 14 Nov 2012 12:47:10 +1030 |
Daniel O'Connor |
Fix debug & load targets for BMP.
|
| Wed, 14 Nov 2012 12:46:48 +1030 |
Daniel O'Connor |
Fix typo
|
| Wed, 14 Nov 2012 12:30:58 +1030 |
Daniel O'Connor |
Add i2c test code
|
| Wed, 14 Nov 2012 12:30:29 +1030 |
Daniel O'Connor |
Catch up with new toolchain location
|
| Wed, 14 Nov 2012 12:30:05 +1030 |
Daniel O'Connor |
Use new delay routine on pin 2 so it doesn't interfere with 1 wire.
|
| Wed, 14 Nov 2012 12:24:44 +1030 |
Daniel O'Connor |
Use corrected delay() routine.
|
| Wed, 14 Nov 2012 12:24:21 +1030 |
Daniel O'Connor |
Fix delay() to be accurate as measured on the cro.
|
